Refrigerant R22, r-22, two 28 oz. Cans, Pro-Seal XL4, Leak Stop & Malco Tool New

Shake can well before installing.

Invert can (turn upside down) when charging so stop leak agent flows with the liquid refrigerant.

Charge only from the low-side of the system.

Refrigerant

R22 Refrigerant R-22

Air Conditioner, Coolers & Freezers, Refrigerant R-22

(2) Large 28 oz. Cans

(1) SUPCO Top-Mount On/Off Valve with 1/4" male flare hose connection.

(1) Malco Pocket Screwdriver with a flat blade and a valve core tool!

Each Can contains, 24 ounces Refrigerant R22 & 

4 ounces Pro Seal XL4

Each can has a total of 28 oz. of product

Our cans "DO NOT" require any special can capers, which ALL LEAK ANYWAY!

You can connect any 1/4" refrigeration hose that has a valve core depressor on the end  to the top 1/4" male flare fitting. It is the same fitting found on the 30 and 15 lb. cans. (1/4" male flare)

The can comes with a nice brass cap to keep the fitting clean and prevent any accidently leaks!

When you figure the cost of those leaky "clamp-on" can tap's.....Our can will bring you more value.

Stop wasting  all that truck space for a couple of pounds of R22.

The can contains 28 oz., which is almost 2 lbs. of refrigerant R22 gas.

(Note: 16 oz. Equals 1 Lb.)

You can list a refrigerant approved by the Environmental Protection Agency (EPA) as long as you include in your item description: 

-- The buyer has to be certified by the EPA.
-- The buyer has to show proof of certification before paying and before the item can be shipped.
Refrigerant R-22 is used in,

Air-Conditioners

Heat Pump Systems

Coolers and Freezers

Some small appliances

ProSeal XL4 is designed for repairing leaks in condensers, evaporators, copper line, and solder joints. 

ProSeal XL4 is a product with epoxy that reacts to water and air. 

When coming in contact with the atmosphere, it forms a seal over the leak.  

If your system stays charged for one day when running, this product will fix most leaks that you encounter.

If there is air and water in your system, pull a deep vacuum on the system and boil moisture out of the system.  

An alternative to pulling a vacuum is to purchase and use ProDry XL4 to turn moisture into synthetic oil. 

This will prevent ProSeal from reacting inside your system.

In most cases. if a system has not leaked below 15 psi, there is typically not air or moisture in the system. 

The system has greater pressure than what the atmospheric pressure is and cannot leak unless the system is below 15 psi.

ProSeal XL4 has twice as much sealing agent as regular ProSeal. 

It is great for repairing those reoccurring leaks in systems.  

Save on costly repair and use ProSeal XL4 instead.

Made for  Refrigeration systems up to 5 Tons. 

Generally, in order to sell Freon (also known as CFC-12) and other refrigerants, the law requires sellers to make sure that the buyer is certified by the Environmental Protection Agency (EPA).

·         The buyer has to be EPA-certified.

·         The buyer has to show proof of certification before paying and before the item is shipped.

*You must be EPA certified to purchase this product and show proof of certification before the item will be shipped.*You have to be certified by the Environmental Protection Agency (EPA), Section 608 or Section 609. *You have to show proof of certification before paying and before the items can be shipped.

·